I need an IDE header for my GCT. Badflash is out of them but is still a source for the cable. Anyone out there still have a header or a cable? About soldering the header, how does one do surface mount stuff? I can solder pretty well with through hole but I'm pretty sure it would be impossible to do it using through hole methods. Do you tin each pad then push the pin down on top of it while heating? Thanks for any help.
-DC
10-16-2002 18:31:55
RE:Need a IDE header / a few questions (modified 0 times)
I'm pretty sure I have an extra IDE header if you still need one. I'm no expert at soldering, but I didn't have any problems soldering the header onto the MB. The pads are already tinned on the motherboard.
--Mike
10-18-2002 09:18:56
RE:Need a IDE header / a few questions (modified 0 times)
i-opener opener laptop notebook computer help
drivers dll free windows dos repair fix linux mac macintosh 2000 95 98 nt pc
configure hardware software sound video netscape explorer network networking
lan wan software cmos fat bios printer card mouse modem ide scsi cd rom
controllers scanner tape hard drive cgi scripts source code mp3
