Quesion 1) I'm adding a switch to SW2 and i'm assuming that i need to remove R208 but i haven't seen reference to this -- i'm sure i'm missing it -- to fully enable the speed selection. Is this right? Are there any other 0 ohm resistors that i need to remove?
Question 2) In regards to the 6702. Did folks come to consensus as to whether the capacitors are needed that are referenced in the datasheet?
05-13-2001 16:44:19
RE:R208 and Cap question on 6702 (ver 3) (modified 0 times)
I can answer your first question, Though its been coverd MORE times now then is needed. YES you need to remove the r208 resister to make the FSB changable. it is located RIGHT by the sw3?? i think switch. Or rather the swich area by the modem. the resister is RIGHT under the modem. You'll see a small white box with a list of resister numbers. its at the very top.
i-opener opener laptop notebook computer help
drivers dll free windows dos repair fix linux mac macintosh 2000 95 98 nt pc
configure hardware software sound video netscape explorer network networking
lan wan software cmos fat bios printer card mouse modem ide scsi cd rom
controllers scanner tape hard drive cgi scripts source code mp3
